The aim of this thesis is to understand and improve the sulphidation of W-based hydrotreating catalysts by understanding and characterising each step of their preparation, from the synthesis to catalytic tests, via a controlled surface chemistry approach (or "CSC", also referred as surface organometallic chemistry, "SOMC", in the literature). This molecular approach opens new avenues for the improvement of W sulphidation, which is one strong limitation for using this metal in hydrotreatment. The core of this study is based on the use of well-defined metallo-organic precursors as precursors of the tungsten sulphide phase, each step of materials preparation being characterised by multiple spectroscopy techniques (IR, NMR, XPS) combined with ab initio molecular modelling.Mono or dinuclear tungsten alkoxides such as [W(OEt)5]2, W(OEt)6 or [W(=O)(OEt)4]2 were grafted on partially dehydroxylated amorphous silica-alumina. Their conversion into sulphide materials reveals that the precursor does not influence significantly the amount of WS2 phase formed (level of sulphidation observed by XPS) as well as catalytic properties in toluene hydrogenation in the presence of aniline. Only [W(OEt)5]2 was used in the following experiments.So as to better understand the genesis of the sulphide phase, CSC materials were characterised before and after sulphidation. Before sulphidation, the use of increasing amounts of W precursor reveals the formation of (1) first, a layer of tungsten surface species grafted on the surface, and (2) second, layers of more mobile species, more loosely bonded to the grafted species. Then, these CSC materials were sulphided into WS2 catalysts (with different W-loading, and different sulphidation temperatures) and were compared to conventionally prepared samples. The results reveal an improvement of tungsten sulphidation for CSC samples already at ambient sulphidation temperature and also at more usual sulphidation temperatures (350°C). Catalytic activities up to 2 times higher than conventional references were also obtained. They are explained in part by the better level of sulphidation of CSC samples and by a different 2D morphology of WS2 crystallites (STEM-HAADF), observed to be hexagonal-like for CSC samples while conventional ones have truncated triangle-like shapes.Then, as non-promoted CSC samples were more active than their conventional counterparts, nickel promoted catalysts (NiWS) were prepared, with the use of different Ni precursors (such as Ni(acac)2), different preparation methods and Ni amounts. This study gives insights into the sulphidation of W and Ni, and reveals that samples prepared via a molecular approach (CSC) can exhibit intrinsic hydrogenation rates up to four times higher than reference catalysts. These results are explained by an optimal balance between the nature of active Ni-W mixed sites and their amount. These interesting results, obtained for non-promoted and Ni-promoted catalysts, show that the use of a molecular approach is suitable to design highly active hydrotreating catalysts.
