Obtaining transparent polycrystalline ceramics became an important technological challenge over the last decade. Their high mechanical (hardness, wear resistance) and physico-chemical (corrosion resistance) properties combined with a high transparency and a reasonable price could lead them to replace glasses or monocrystals as sapphire in optical applications. The main parameters to control in order to obtain highly transparent polycrystalline alpha-alumina (PCA) are the porosity size and amount as for the other transparent materials. However, as PCA is a birefringent material, the grain size also needs to be controlled. That’s why PCA should possess after sintering grains as small as possible (bigger than 0.5 µm) and a porosity closed to 0.00% with nanometric pores. This particular microstructure is usually obtained in ~ 15 hours by combining natural sintering in air with a post Hot Isostatic Pressing (HIP) treatment. In our study, the Spark Plasma Sintering (SPS) technique was used as it enables to obtain fully dense ceramics in shorter times while limiting the grain growth. First, a protocol to obtain a pure transparent PCA was established. It consists on preparing green bodies with a controlled particle’s packing before sintering. Mainly, the particle’s packing has to be macroscopically homogeneous and without agglomerates. Moreover, the pore size distribution should be the narrowest. The SPS sintering cycle was also optimised to obtain the highest optical transmission. Then, a doping protocol with grain growth inhibitors was optimised. The nature of the doping salt has a secondary effect on optical properties compared to a thermal treatment applied before sintering. Depending on the doping agent nature and/or amount, the densification temperature changes. The SPS sintering cycle has thus to be adapted. The doping agent amount has to be optimised to obtain a fine microstructure after sintering without second phase particles. Different doping agents have been compared (magnesium Mg, lanthanum La and zirconium Zr). The sample having the highest optical properties was doped with 200 cat ppm of lanthanum. Finally, an optimisation of the powder’s morphology (finer and more spherical) was performed. Moreover, the lanthanum doped alpha-alumina slurry’s preparation was optimized using centrifugation. All these processes have enabled us to obtain one of the most transparent PCA sample ever reported in the literature. It possesses an optical transmission of 68% and a grain size around 300 nm. Its mechanical properties (hardness, wear resistance) are higher than the ones of a sapphire monocrystal.
