The negative impact of automobiles on the environment has led to increased severity in the legislation concerning environmental protection. The problems encountered in the efforts intended to improve the efficiency of the spark ignition engine are derived from its inefficient operation under partial loads. The variable intake valve lift is capable of significant changes aiming at lower fuel consumption, especially in the frequent use area: low torque, low speed. An alternative to the experimental study of fluid flow is the approach by numerical simulation, CFD, using the software ANSYS-Fluent. The main purpose of the present doctoral thesis was to determine the fluid flow velocity during the intake, for two intake valve lift laws, when the engine is running at 815 rpm, and with an opening of the throttle plate at 21.6°. To do this, we have used two numerical simulation models: one two-dimensional, and one three-dimensional. The study by numerical simulation made it possible to clarify some important issues regarding the air flow velocity into the cylinder, and the level of turbulence.